Updated Free Juniper JN0-363 Test Engine Questions with 293 Q&As
The Best JNCIS-SP JN0-363 Professional Exam Questions
NEW QUESTION # 149
Exhibit button
Which two statements are correct about the service provider MPLS network shown in the exhibit? (Choose two.)
- A. Traffic from Network 1 to Network 3 and from Network 1 to Network 4 can share the same label-switched path.
- B. R3 will perform a label swap operation on the transport MPLS label.
- C. R3 will perform a label pop operation on the transport MPLS label.
- D. Traffic from Network 1 to Network 3 and traffic from Network 1 to Network 4 each need their own unique label-switched path.
Answer: B,C
NEW QUESTION # 150
You want to share routes between two routing instances that you have configured?
What are two ways to accomplish this task? (Choose two.)
- A. Create a forwarding instance.
- B. Use a non-forwarding instance.
- C. Use a RIB group.
- D. Configure an instance import policy
Answer: C,D
Explanation:
static route with a next-hop of next-table pointing to the appropriate routing table which contains more accurate information rib-groups to mirror routing information from one route-table to another. However, in many cases, in order to make this work, interface-routes also need to be mirrored. RIB Group policy can be used to constrain the routing information instance-import and instance-export statements configured within the individual routing-instances to leak routes from one table to another. Again, policy can be used here to constrain the routing information. This method is more straightforward than the rib-group method A final approach is to use physical interfaces or logical-tunnels to stitch routing-instances and use a routing protocol or static routes across this connection between the two routing-instances.
To share routes between two routing instances on a Junos device, you can configure an instance import policy in one or both instances to import routes from the other instance. Alternatively, a RIB (Routing Information Base) group can be used to share routes between instances.References:
Routing Instances Overview, Juniper Networks Documentation
RIB Groups Configuration Guide, Juniper Networks Documentation
NEW QUESTION # 151
Which two statements are correct when using LDP? (Choose two.)
- A. The lnet.3 table will contain only the paths explicitly defined.
- B. LDP label-switched paths are created by configuring LDP on the loopbacK Interface.
- C. The inet.3 table will contain a full mesh of label-switched paths to other LDP-enabled routers.
- D. LDP label-switched paths are created by configuring LDP on at least one physical router interface.
Answer: B,C
NEW QUESTION # 152
Click the Exhibit button.
Referring to the exhibit, you have an established RSVP LSP between R1 and R4 when you experience a link failure between R2 and R3.
Which two statements are correct? (Choose two.)
- A. R3 sends a PathTear message downstream to R4 signaling the link failure.
- B. R2 sends a PathTear message upstream to R1 signaling the link failure.
- C. R2 sends a ResvTear message upstream to R1 signaling the link failure.
- D. R3 sends a ResvTear message downstream to R4 signaling the link failure.
Answer: A,C
NEW QUESTION # 153
You want to disable MAC learning only for interface ge-0/0/0.0 on an MX Series device.
Which syntax will accomplish this task?
- A.
- B.
- C.
- D.
Answer: C
Explanation:
https://www.juniper.net/documentation/en_US/junos/topics/task/configuration/layer-2-services-mac-bridge-domain-or-logical-interface-disabling-learning-for.html
NEW QUESTION # 154
What Is a key differentiator of generate routes from aggregate routes?
- A. Generate routes use a forwarding next hop.
- B. Generate routes cannot be used as a gateway of last resort.
- C. Generate routes have a default preference value of 210.
- D. Generate routes have a default next-hop value of reject.
Answer: A
Explanation:
https://www.networkfuntimes.com/junos-aggregate-routes-vs-generate-routes-how-to-summarise-on-juniper-routers/
NEW QUESTION # 155
You confirm that the R2 and R3 routers are receiving a BGP route to the 203.0.113.0/24 network, but both routers display the route as hidden. Referring to the exhibit, which two actions solve this problem? (Choose two.)
- A. Apply the routing policy on R1 as an export policy to the IBGP group.
- B. Configure a routing policy on R1 that sets the next hop for the 203.0.113.0/24 BGP route to the IP address that R1 uses for IBGP peering.
- C. Apply the touting policy on R1 as an Import policy to the IBGP group.
- D. Configure a routing policy on R1 that sets the next hop for the 203.0.113.0/24 BGP route to the IP address that R1 uses for EBGP peering.
Answer: B,D
NEW QUESTION # 156
Click the Exhibit button. In the exhibit, all routers are sending routes to Router B.Which routes will be advertised from Router B to Router E?
- A. BGP routes learned from Routers A and C only
- B. BGP routes learned from Routers A, C, and D only
- C. BGP routes learned from Router D only
- D. BGP routes learned from Router A only
Answer: B
NEW QUESTION # 157
Click the Exhibit button.
Your co-worker configures the ge-0/0/0 interface with an IPv6 address of 2001:db8:0:9::/64. After committing the configuration, your co-worker executes the command shown in the exhibit.
What is the fe80::206:aff:fe0e:e01/64 address in this scenario?
- A. the link-local address
- B. the loopback address
- C. the statically assigned address
- D. the multicast address
Answer: A
NEW QUESTION # 158
What are three valid BGP message types? (Choose three.)
- A. Open
- B. Refresh
- C. Keepalive
- D. Hello
- E. Route
Answer: A,B,C
NEW QUESTION # 159
What is the correct simplification of the 2001:0000:0000:0234F:0000:CBFF:5CA1:A001 IPv6 address?
- A. 2001::234F::CBFF:5CA1:A001
- B. 2001:0:0:234F:0:CBFF:5CA1:A1
- C. 2001::234F:CBFF:5CA1:A001
- D. 2001::234F:0 :CBFF:5CA1:A001
Answer: D
NEW QUESTION # 160
Which two statements are correct about the service provider MPLS network shown in the exhibit? (Choose two.)
- A. R3 is considered a transit router.
- B. R3 is considered a PE router.
- C. R3 is considered an ingress router.
- D. R3 is considered a P router.
Answer: B,D
NEW QUESTION # 161
Referring to the exhibit, which statement is correct?
- A. R1 will advertise only the 10.200.2.0/24 prefix to the 192.168.1.5 neighbor.
- B. R1 will advertise the 10.200.1.0/24, 10.200.2.0/24, and 10.200.3.0/24 prefixes to the 192.168.1.5 neighbor.
- C. R1 will advertise only the 10.200.1.0/24 prefix to the 192.168.1.5 neighbor.
- D. R1 will advertise only the 10.200.3.0/24 prefix to the 192.168.1.5 neighbor.
Answer: B
NEW QUESTION # 162
Exhibit
The exhibit shows a topology with 1 Gbps interfaces between routers, and four RSVP LSPs operating with the respective bandwidth reservations.
Which path will be selected for a new LSP from R4 to R6 with a bandwidth reservation of 400 Mbps?
- A. R4 -> R5 -> R2 -> R3 -> R6
- B. R4 -> R5 -> R6
- C. R4 -> R1 -> R2 -> R5 -> R6
- D. R4 -> R1 -> R2 -> R3 -> R6
Answer: C
NEW QUESTION # 163
An OSPF router does not have a router ID configured.
In this scenario, which statement is correct about the router ID?
- A. A router ID will not be assigned until it is manually configured.
- B. The Junos OS will use the IP address assigned to the loopback interface for the router ID.
- C. The Junos OS will use the IP address assigned to the Interface with the highest priority.
- D. The Junos OS will use the IP address assigned to the interface with the lowest MAC address.
Answer: A
NEW QUESTION # 164
You are bringing a new network online with three MX Series devices enabled for STP. No root bridge priority has been configured. Which statement is true in this scenario?
- A. The device with the highest MAC address will be elected as the root bridge.
- B. The device with the lowest numerical lo0 IP address will be elected as the root bridge.
- C. The device with the highest numerical lo0 IP address will be elected as The bridge.
- D. The device with the lowest MAC address will be elected as the root bridge.
Answer: D
NEW QUESTION # 165
What Is a key differentiators of generate routes from aggregate routes?
- A. Generate routes have a default preference value of 210.
- B. Generate routes use a forwarding next hop.
- C. Generate routes cannot be used as a gateway of last resort.
- D. Generate routes have a default next-hop value of reject.
Answer: A
NEW QUESTION # 166
Which two steps are required to enable MPLS on a physical interface in Junos? (Choose two.)
- A. Add the loopback interface under protocols mpls.
- B. Add family mpls on the loopback interface.
- C. Add family mpls on the interface.
- D. Add the interface under protocols mpls.
Answer: C,D
NEW QUESTION # 167
Click the Exhibit.
You are planning the addition of a new EX3400 Series device to the network (EX-3400-7) to service MSTI-1 and MSTI-2.
Referring to the exhibit, which requirement must be met on EX-3400-7 for the MSTP instances to become fully operational and resilient?
- A. The MSTP configuration-name must be the same.
- B. The MSTP revision-level must be incremented.
- C. The CIST must be extended to EX-3400-7.
- D. The bridge-priority must match EX-3400-5 and EX-3400-6.
Answer: A
NEW QUESTION # 168
Exhibit
Referring to the exhibit, which statement is true about VRRP?
- A. Both routers are in the same state because they have the same VRRP priority.
- B. RRP Is functioning normally in active/active mode.
- C. VRRP communication between the two devices is not functioning correctly.
- D. The routers should use different virtual IP addresses for VRRP to function correctly.
Answer: D
NEW QUESTION # 169
Which IPv6 extension header notifies intermediary devices that they must inspect the packet's options?
- A. fragment header
- B. routing header
- C. destination options header
- D. hop-by-hop options header
Answer: B
Explanation:
https://en.wikipedia.org/wiki/IPv6_packet
NEW QUESTION # 170
......
The JN0-363 exam is a comprehensive exam that covers a wide range of topics, including routing policies, OSPF, BGP, MPLS, Layer 2 VPNs, Layer 3 VPNs, multicast, and many more. JN0-363 exam is designed to test the candidate's understanding of the concepts and technologies used in service provider networks. JN0-363 exam is conducted in a proctored environment and consists of multiple-choice questions, scenario-based questions, and simulations.
Try 100% Updated JN0-363 Exam Questions [2024]: https://www.exam4docs.com/JN0-363-study-questions.html
Pass JN0-363 Exam - Real Questions and Answers: https://drive.google.com/open?id=1mB2nzYBOzmtkLaxKmg20QBqhTKcCoY2x
