[UPDATED 2023] Getting 2V0-41.20 Certification Made Easy!
2V0-41.20 Exam Crack Test Engine Dumps Training With 95 Questions
NEW QUESTION # 56
An NSX administrator noticed that the nsxcli command times out after 600 secs of idle time.
Which CLI command disables the nsxcli time out value on NSX Manager?
- A. set cli-timeout 0
- B. set cli-timeout enabled
- C. set cli-timeout 1
- D. set cli-timeout disabled
Answer: A
Explanation:
Explanation
"
https://vdc-download.vmware.com/vmwb-repository/dcr-public/cc42e3c1-eb34-4567-a916-147e79798957/82646
https://www.virten.net/2020/06/quick-tip-remove-nsx-t-ssh-and-http-session-timeout/
NEW QUESTION # 57
An NSX administrator noticed that the nsxcli command times out after 600 secs of idle time.
Which CLI command disables the nsxcli time out value on NSX Manager?
- A. set cli-timeout 0
- B. set cli-timeout enabled
- C. set cli-timeout 1
- D. set cli-timeout disabled
Answer: A
Explanation:
Reference:
" https://vdc-download.vmware.com/vmwb-repository/dcr-public/cc42e3c1-eb34-4567-a916-147e79798957/8264605c-a5e1-49a8-b603-cc78621eeeab/cli.html#set%20cli-timeout%20%3Ctimeout%3E
https://www.virten.net/2020/06/quick-tip-remove-nsx-t-ssh-and-http-session-timeout/
NEW QUESTION # 58
Where are Distributed Firewall logs containing access decisions stored?
- A. Hypervisor transport node
- B. NSX Edge
- C. NSX Manager
- D. NSX API
Answer: C
NEW QUESTION # 59
A customer has a network where BGP has been enabled and the BGP neighbor is configured on the Tier-0 Gateway. A NSX-T Data Center administrator used the get logical-routers command to retrieve this information:
Which two commands must be executed to check BGP neighbor status? (Choose two.)
- A. vrf 4
- B. sa-nsxedge-01(tier0_dr)> get bgp neighbor
- C. sa-nsxedge-01(tier0_sr)> get bgp neighbor
- D. vrf 1
- E. vrf 3
- F. sa-nsxedge-01(tier1_sr)> get bgp neighbor
Answer: C,E
NEW QUESTION # 60
A DevOps user has deployed a Kubernetes Pod in vSphere.
What does the term ClusterIP represent within NSX-T?
- A. Deployment of Distributed Load Balancing service.
- B. Deployment of T1 with NLB service.
- C. Deployment of Distributed Router.
- D. Deployment of T0 and T1
Answer: A
NEW QUESTION # 61
An NSX administrator is creating a Tier-1 Gateway configured in Active-Standby High Availability Mode. In the event of node failure, the failover policy should not allow the original failed node to become the Active node upon recovery.
Which failover policy meets this requirement?
- A. Preemptive
- B. Enable Preemptive
- C. Disable Preemptive
- D. Non-Preemptive
Answer: D
NEW QUESTION # 62
Which profile must be attached to the ESXi cluster to prepare the host for NSX-T Data Center?
- A. Host Profile
- B. Switching Profile
- C. Uplink Profile
- D. Transport Node Profile
Answer: D
NEW QUESTION # 63
Refer to the exhibit.
Which NAT type must the NSX-T Data Center administrator create on the Tier-0 or Tier-1 Gateway to allow Web VM to initiate communication with public networks?
- A. 1:1 NAT
- B. SNAT
- C. Reverse NAT
- D. DNAT
Answer: B
NEW QUESTION # 64
Which three services are compatible with VRF Lite? (Choose three.)
- A. DHCP
- B. NAT
- C. VPN
- D. Intrusion Detection
- E. Load Balancer
Answer: B,C,E
NEW QUESTION # 65
Which three services are compatible with VRF Lite? (Choose three.)
- A. Intrusion Detection
- B. DHCP
- C. NAT
- D. VPN
- E. Load Balancer
Answer: A,B,C
Explanation:
Explanation
VRF Lite is not compatible with the following services:
-VPN
-Load Balancer
Taken from NSX-T ICM 3.0 Lecture Manual.
NEW QUESTION # 66
An NSX administrator is reviewing syslog and notices that Distributed Firewall Rules hit counts are not being logged. What could cause this issue?
- A. Syslog is not configured on the NSX Manager
- B. Distributed Firewall Rule logging is not enabled
- C. Syslog is not configured on the ESXi transport node
- D. Zero Trust Security is not enabled
Answer: B
NEW QUESTION # 67
Which network virtualization technologies can be used with an Ethernet VPN (EVPN) deployment in NSX-T Data Center? (Choose two.)
- A. Open Shortest Path First (OSPF)
- B. Virtual Extensible Local Area Network (VXLAN)
- C. Virtual Routing and Forwarding (VRF)
- D. Multiprotocol Label Switching (MPLS)
- E. Multiprotocol Border Gateway Protocol (MP-BGP)
Answer: B,C
NEW QUESTION # 68
What needs to be configured on a Tier-0 Gateway to make NSX Edge Services available to a VM on a VLAN- backed logical switch?
- A. VLAN Uplink
- B. Downlink interface
- C. Loopback Router Port
- D. Service interface
Answer: D
Explanation:
Explanation
"The service interface is a special-purpose port to enable services for mainly VLAN-based networks.
North-south service insertion is another use case that requires a service interface to connect a partner appliance and redirect north-south traffic for partner services. Service interfaces are supported on both active-standby Tier-0 logical routers and Tier-1 routers. Firewall, NAT, and VPNs are supported on this interface. The service interface is also a downlink"
NEW QUESTION # 69
Where do you configure the VLANs used in VRF Lite? (Choose two.)
- A. downlink interface of the default Tier-0 gateway
- B. uplink interface of the default Tier-0 gateway
- C. uplink trunk segment
- D. uplink interface of the VRF gateway
- E. segment connected to the Tier-1 gateway
Answer: B,D
Explanation:
In VRF Lite configuration, VLANs are configured on the uplink interfaces of both the default Tier-0 gateway and the VRF gateway. The default Tier-0 gateway is responsible for routing between the different VRFs, while the VRF gateway is responsible for routing within a specific VRF. Reference: https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.1/nsxt_31_admin_guide/GUID-1F07C737-DA0A-46E9-9ED9-C7D8C6DA3F7B.html
NEW QUESTION # 70
An administrator has a requirement to have consistent policy configuration and enforcement across NSXT instances. What feature of NSX-T Data Center fulfills this requirement?
- A. Load balancer
- B. Policy-driven configuration
- C. Federation
- D. Multi-hypervisor support
Answer: B
NEW QUESTION # 71
Which three protocols could an NSX administrator use to transfer log messages to a remote log server? (Choose three.)
- A. TCP
- B. SSH
- C. TLS
- D. HTTPS
- E. UDP
- F. SSL
Answer: A,C,E
NEW QUESTION # 72
Refer to the exhibit.
Which NAT type must the NSX-T Data Center administrator create on the Tier-0 or Tier-1 Gateway to allow Web VM to initiate communication with public networks?
- A. 1:1 NAT
- B. SNAT
- C. Reverse NAT
- D. DNAT
Answer: B
NEW QUESTION # 73
An NSX administrator is troubleshooting a connectivity issue with virtual machines running on an ESXi transport node. Which feature in the NSX UI shows the mapping between the virtual NIC and the host's physical adapter?
- A. Switch Visualization
- B. IPFIX
- C. Activity Monitoring
- D. Port Mirroring
Answer: A
NEW QUESTION # 74
An NSX administrator wants to create a Tier-0 Gateway to support equal cost multi-path (ECMP) routing.
Which failover detection protocol must be used to meet this requirement?
- A. Virtual Router Redundancy Protocol (VRRP)
- B. Host Standby Router Protocol (HSRP)
- C. Bidirectional Forwarding Detection (BFD)
- D. Beacon Probing (BP)
Answer: C
NEW QUESTION # 75
An NSX administrator would like to export syslog events that capture messages related to NSX host preparation events.
Which message ID (msgid) should be used in the syslog export configuration command as a filter?
- A. FABRIC
- B. SYSTEM
- C. GROUPING
- D. MONITORING
Answer: A
Explanation:
Explanation
https://docs.vmware.com/en/VMware-NSX-T-Data-Center/3.0/nsxt_30_admin.pdf
NEW QUESTION # 76
An NSX administrator is using ping to check connectivity between VM1 running on ESXi1 to VM2 running on ESXi2. The ping tests fails. The administrator knows the maximum transmission unit size on the physical switch is 1600.
Which command does the administrator use to check the VMware kernel ports for tunnel end point communication?
- A. vmkping ++netstack=geneve -d -s 1572 <destination IP address>
- B. esxcli network diag ping -H <destination IP address>
- C. esxcli network diag ping -I vmk0 -H <destination IP address>
- D. vmkping ++netstack=vxlan-d -s 1572 <destination IP address>
Answer: D
NEW QUESTION # 77
Which three protocols could an NSX administrator use to transfer log messages to a remote log server?
(Choose three.)
- A. TCP
- B. SSH
- C. TLS
- D. HTTPS
- E. UDP
- F. SSL
Answer: A,C,E
Explanation:
Explanation
https://www.vmware.com/content/dam/digitalmarketing/vmware/en/pdf/certification/vmware-2vo-41.20-exam-p
NEW QUESTION # 78
......
VMware 2V0-41.20 exam, also known as the Professional VMware NSX-T Data Center exam, is designed for IT professionals who want to validate their skills and knowledge in implementing VMware NSX-T Data Center solutions. Professional VMware NSX-T Data Center certification exam is intended for candidates who have a deep understanding of networking and security concepts, as well as experience working with VMware NSX-T Data Center.
2V0-41.20 Exam Dumps Contains FREE Real Quesions from the Actual Exam: https://www.exam4docs.com/2V0-41.20-study-questions.html
Obtain the 2V0-41.20 PDF Dumps Get 100% Outcomes Exam Questions For You To Pass: https://drive.google.com/open?id=118aFGv01i9HU8unemzrod9e5KvBt-mzk
